How to Pair the CloudConnector to the Meter Sensor

Print article Email to friend
5.00

To pair the Meter Sensor to the CloudConnector, press and hold the button on the side of the CloudConnector. The status light will turn off. Keep holding the button until the status light comes back on solid. Now go to your Meter Sensor and press the button in the battery compartment.

The expected status light behaviour for the Meter Sensor after pressing the button in the battery compartment is; Eventually solid ON>flashing> triple blinks of GREEN(good detection)>OFF (conserve battery) Disk type meter detection may take longer than a digital type meter. (meter sensor status light behaviour will be different if the sensor is NOT installed on an electrcity meter)

If the sync was succesful, the status light on the CloudConector will go off, then an occaisional flash when a Meter Sensor transmission has been received.

If unsuccessful, the CloudConnector Status Light will still be ON, try the sync again. If you are still unsuccesful, move the CloudConnector closer to the meter location and re-attempt the sync. NOTE: On occaison, if the meter sensor and CloudConnector are within 3' of each other during the pairing process or if the CloudConnector is sitting on top or very close to your WiFi Router, the devices may not pair correctly. 

 

NOTE: It is best to have a high load on the meter during the Meter Sensor setup on your electricity meter. A high load will help the Meter Sensor detect your meter somewhat quicker. A good example of a high load would be a clothes dryer or oven.

How to Pair the CloudConnector to the Meter Sensor

To pair the Meter Sensor to the CloudConnector, press and hold the button on the side of the CloudConnector. The status light will turn off. Keep holding the button until the status light comes back on solid. Now go to your Meter Sensor and press the button in the battery compartment.

The expected status light behaviour for the Meter Sensor after pressing the button in the battery compartment is; Eventually solid ON>flashing> triple blinks of GREEN(good detection)>OFF (conserve battery) Disk type meter detection may take longer than a digital type meter. (meter sensor status light behaviour will be different if the sensor is NOT installed on an electrcity meter)

If the sync was succesful, the status light on the CloudConector will go off, then an occaisional flash when a Meter Sensor transmission has been received.

If unsuccessful, the CloudConnector Status Light will still be ON, try the sync again. If you are still unsuccesful, move the CloudConnector closer to the meter location and re-attempt the sync. NOTE: On occaison, if the meter sensor and CloudConnector are within 3' of each other during the pairing process or if the CloudConnector is sitting on top or very close to your WiFi Router, the devices may not pair correctly. 

 

NOTE: It is best to have a high load on the meter during the Meter Sensor setup on your electricity meter. A high load will help the Meter Sensor detect your meter somewhat quicker. A good example of a high load would be a clothes dryer or oven.